Table of Contents
Advertisement
PM Control by APM
This field allows you to use the Advanced Power Management device
to enhance the Max. Power Saving mode and stop the CPU's internal
clock. If the Max. Power Saving is not enabled, this will be preset to
NO.
Video Off After
This field specifies the mode after which the Video Off feature is
enabled. The options are Doze, Standby, Suspend, and N/A.
Video Off Method
This field defines the Video Off features. There are three options.
V/H SYNC + Blank
DPMS
Blank Screen
PWRON After PW-Fail
In case of power failure, the system can be configured to power on or
to remain off when the power returns. These two settings are Former-
Sts and Off respectively. The default setting for this field is Off.
Soft-Off by PWRBTN
This field defines the power-off mode when using an ATX power
supply. The Instant Off mode allows powering off immediately upon
pressing the power button. In the Delay 4 Sec mode, the system powers
off when the power button is pressed for more than four seconds or
enters the suspend mode when pressed for less than 4 seconds. The
default value is Instant Off.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
Doze Mode
When enabled, and after the set time of system inactivity, the CPU
clock will run at a slower speed while all other devices still operate at
full speed.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices
except the CPU will be shut off.
MI7VGA User's Manual
Chapter 6 BIOS Configuration
Default setting, blank the screen and turn
off vertical and horizontal scanning.
Allows the BIOS to control the video
display card if it supports the DPMS
feature.
This option only writes blanks to the video
buffer.
43
Advertisement
Table of Contents
