Time; Drive A / Drive B - TMC LI7WM User Manual

Time

The time format is:
To set the t i me, highlight the "Time" field and use the <PgUp>/
<PgDn> or +/- keys to set the current time.
IDE Primary HDDs / IDE Secondary HDDs
The onboard PCI IDE connectors provide Primary and Secondary
channels for connecting up to four IDE hard disks or other IDE devices.
Each channel can support up to two hard disks; the first is the "Master"
and the second is the "Slave".
Press <Enter> to configure the hard disk. The selections include Auto,
Manual, and None. Select 'Manual' to define the drive information
manually. You will be asked to enter the following items.
CYLS :
HEAD :
PRECOMP :
LANDZ :
SECTOR :
SIZE :
The Access Mode selections are as follows:

Drive A / Drive B

These fields identify the types of floppy disk drive A or drive B that
has been installed in the computer. The available specifications are:
360KB
5.25 in.
NOTE: The specifications of your drive must match with the drive
table. The hard disk will not work properly if you enter
incorrect information in these fields. If your hard disk drive
type is not matched or listed, you can use Type User to define
your own drive type manually.
39
Hour : 00 to 23
Minute :
Second :
Number of cylinders
Number of read/write heads
Write precompensation
Landing zone
Number of sectors
Automatically adjust according to the configuration
1.2MB
720KB
5.25 in. 3.5 in.
Chapter 6 BIOS and System Setup
00 to 59
00 to 59
Auto
Normal (HD < 528MB)
Large (for MS-DOS only)
LBA (HD > 528MB and
supports Logical Block
Addressing)
1.44MB
3.5 in.
LI7WM User's Manual
2.88MB
3.5 in.