Table of Contents
Advertisement
BMC Activity LED (LE2)
A BMC Heartbeat LED is located at LE2
on the serverboard. When LE2 is on, the
BMC (Baseboard Management Controller)
is active.
HDD/SATA LED (LE3)
An HDD/SATA LED is located at LE3 on the
serverboard. This LED indicates the status
of hard drive activitiy or SATA drive activity
supported by the South Bridge.
Rear UID LED (LE4)
The Rear UID LED is located at LE4 on
the serverboard. Refer to Section 5-7 for
details.
5-10 Serial ATA Ports
Serial ATA Connections
A Front Panel Add-On Card header is located
at JF2 on the serverboard. This header
provides onboard SATA support. Plug an
add-on card in JF2 to use SATA connections.
These connections provide serial-link signal
transmission, which is faster than that of the
traditional Parallel ATA.
Chapter 5: Advanced Serverboard Setup
Status Defi nition
On
Off
5-19
HDD/SATA LED
(LE3)
HDD/SATA
connected
No connection
Advertisement
Table of Contents
