Table of Contents
Advertisement
5-4
Installing Memory
CAUTION! Exercise extreme care when installing or removing DIMM
!
modules to prevent any possible damage.
Memory Support
The X8DTT-H series serverboard supports up to 192 GB of Registered ECC or
48 GB of Unbuffered ECC/Non-ECC DDR3 1333 MHz/1066 MHz/800 MHz in 12
DIMM slots.
Note: Check the Supermicro web site for recommended DIMMs.
Installing Memory Modules
1.
Insert each memory module vertically into a slot following the charts below.
Pay attention to the notch along the bottom of the module to prevent inserting
it incorrectly.
2.
Gently
press down on the DIMM until it snaps into place in the slot (see
Figure 5-2).
3.
Repeat for all DIMMs. See tables below and on following pages.
3 DIMMs
P1 DIMM1A
6 DIMMs
P1 DIMM1A
Branch 0
6 DIMMs
1A
12
1A
1B
DIMMs
Populating Memory for Optimal Performance
(Single CPU Confi guration)
Branch 0
P1 DIMM2A
P1 DIMM1B
P1 DIMM2A
Populating Memory for Optimal Performance
(Dual CPU Confi guration)
CPU1
Branch 1
Branch 3
2A
3A
2A
2B
3A
Chapter 5: Advanced Serverboard Setup
Branch 1
P1 DIMM2B
Branch 0
1A
3B
1A
1B
5-7
Branch 2
P1 DIMM3A
P1 DIMM3A
P1 DIMM3B
CPU2
Branch 1
Branch 3
2A
3A
2A
2B
3A
3B
Advertisement
Table of Contents
