Table of Contents
Advertisement
SUPERSERVER 2026TT-HxRF User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 2026TT are two X8DTT series dual processor
serverboards (see list on previous page), which are based on Intel's 5520 + ICH10R
chipset. Below are the main features of the serverboards. Note that the features on
each board are quadrupled for the server, which includes four nodes.
Processors
Each X8DTT series serverboard supports two Intel® 5600/5500 series processors
in LGA1366 sockets. Please refer to our web site for a complete listing of supported
processors (www.supermicro.com).
Memory
Each X8DTT has twelve DIMM sockets that can support up to 192 GB of regis-
tered ECC DDR3-1333/1066/800 SDRAM or 48 GB of unbuffered ECC/Non-ECC
1333/1066/800 MHz memory for a maximum of 768 GB for the system. See Chapter
5 Section 6 for more details on installing memory into the system.
Onboard SAS (2026TT-H6 models only)
An LSI 2108 SAS controller is integrated into a daughter card to provide six SAS
ports per node. The hot-swap SAS drives are connected to a backplane that pro-
vides power, bus termination and confi guration settings.
Note: The operating system you use must have RAID support to enable the
hot-swap capability and RAID function of the SAS drives. RAID 0, 1, 5 and
10 and 6 are supported. Refer to the following ftp site for setup guidelines
<ftp://ftp.supermicro.com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf>.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 10 and
5 are supported. Refer to the support area of our web site for procedures on set-
ting up RAID on your system.
1-2
Advertisement
Table of Contents
