TSC TDP-643R Plus User Manual page 23
Thermal transfer / direct thermal bar code printer
Hide thumbs
Also See for TDP-643R Plus:
- Service manual (40 pages) ,
- Programming manual (434 pages) ,
- Programming manual (252 pages)
Table of Contents
Advertisement
indicators are flashing between
READY and ERROR.
10. A large amount of black
graphics printed on the label
and the darkness is not
adequate.
"Dump Mode" to debug.
Check if the label gap is too small.
The label gap must be larger than
1/16 inch.
Check and remove any stuck label on
gap sensor.
Run the printer at a slower speed.
- 20 -
Advertisement
Table of Contents
Need help?
Do you have a question about the TDP-643R Plus and is the answer not in the manual?