Peel-Off Function - TSC TDP-643R Plus User Manual

Thermal transfer / direct thermal bar code printer

Hide thumbs Also See for TDP-643R Plus:

Table of Contents

3.3 Peel-off Function

In peel-off function, the printed label will be stripped from the liner paper

automatically. Follow the steps below:

Follow the directions in the previous section "Installing the label" to load the

label well.

Press the FEED button until about 3 inches of the label extends out of the label

dispense opening. Open the front cover.

Tear off the label from the liner paper. Place the front edge of the liner paper

between the platen and the stripping roller and push in until it stops.

Press the FEED button until the liner paper is out of the bottom of the stripping

roller.

Push the paper release button to the back and hold it to adjust the position of the

label. Rewind the label roll until the label is pulled tight between the platen and

the stripping roller. When the labels have been properly adjusted, release the

paper release button.

Press and release the FEED button until the front edge of next label is visible.

Close the front cover. The installation now is complete.

- 9 -

Table of Contents

Do you have a question about the TDP-643R Plus and is the answer not in the manual?