TSC TDP-225 Installation Manual

Hide thumbs Also See for TDP-225:

Available languages

USB Installation Guide

1. Place the printer on a flat, secure surface.

2. Make sure the power switch is off.

3. Connect the printer to the computer with the USB cable.

4. Plug the power cord into the power supply connector at the rear of the printer, and then plug

the power cord into a properly grounded receptacle. Turn on the printer.

5. Insert the CD-ROM at CD-ROM drive after hardware installed properly. Please click "Windows

Driver Setup" to start.

6. Select "Install printer drivers" to next.

7. Select "Install a driver for a Plug and Play printer" to next.

Page 1 of 2

Table of Contents

Do you have a question about the TDP-225 and is the answer not in the manual?

Page 1 USB Installation Guide 1. Place the printer on a flat, secure surface. 6. Select “Install printer drivers” to next. 2. Make sure the power switch is off. 3. Connect the printer to the computer with the USB cable. 4. Plug the power cord into the power supply connector at the rear of the printer, and then plug the power cord into a properly grounded receptacle.
Page 2 8. Enter the “Printer name” to next. 10. Windows has finished installing the software for this device. Click “Close” to exit the wizard. 9. Click “Finish” to install the Windows Driver. Page 2 of 2...
Page 3 ALTAREX jest wiodącym dostawcą całej gamy urządzeń do systemów informatycznych wykorzystujących automatyczną identyfikację produktów, w oparciu o technikę kodów kreskowych, jak również z zastosowaniem nowych technologii, na przykład RFID. OFERUJEMY :   Weryfikatory jakości kodów kreskowych  Czytniki kodów kreskowych ...