D-Link DES-1228/ME User Manual page 141

The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-256)
Type
VLAN
Source MAC
Destination MAC
802.1p
Ethernet Type
The window shown below is the Access Profile Configuration window for IP.
DES-1228/ME Layer 2 Fast Ethernet Managed Switch
Figure 9- 2. Access Profile Configuration window (Ethernet)
Description
Type in a unique identifier number for this profile set. The number is used to set the relative
priority for the profile. Priority is set relative to other profiles where the lowest profile ID has
the highest priority. If a conflict occurs among configured access rules, the profile ID
establishes relative priority of the rules. The value can be set from 1 to 256 however there is
a limit to the total number of profiles that can be created.
Select profile based on Ethernet (MAC Address) or IP address. This will change the menu
according to the requirements for the type of profile.
•
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
•
Select IP to instruct the Switch to examine the IP address in each frame's
header.
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
Enter a MAC address mask for the source MAC address.
Enter a MAC address mask for the destination MAC address.
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
128