Oil Level Switch - Sym Jet 50 Service Manual

Oil Level Switch

Troubleshooting
If the oil level in oil tank is in specified level,
but the oil level indicator still goes on.
1. Remove body cover.
2. Disconnect oil gauge wire, and turn the
main switch to ON position.
Indicator light up
Short-circuit between
indicator and oil
gauge
If there is no oil in oil tank or low oil level, but
the oil level indicator still not goes on.
1. Remove body cover.
2. Disconnect oil gauge wire and connect a
jump wire among connector, and then turn
the main switch to ON position.
Indicator not light up
Poor wire connection
3. Disconnect oil gauge connector, and
check voltage between wire and ground.
No voltage
Open-circuit between
oil gauge and
indicator.
Blown bulb
Removal/Installation
Remove oil tank.
Remove oil level switch from the oil tank.
Install the oil level switch in reverse order of
removal procedures.
This chapter Contents
Indicator not light up
Malfunction of oil
gauge
Indicator light up
Malfunction of oil
gauge
Voltage
Malfunction of oil
gauge
Poor connection of oil
gauge
15. ELECTRICAL EQUIPMENT
Fuse
Main switch
Indicator
Oil level switch
Main switch
Fuse
Indicator
Oil level switch
Oil level switch
15-15