Sym Jet 50 Service Manual page 106

Install the rubber pad into the groove correctly.
Place the master cylinder onto handlebar, and
install the bolts.
Install the brake lever, and connect leads to
brake lamp switch.
Connect brake hoses with 2 new washers.
Tighten the brake hose bolt to the specified
torque value.
Make sure the hose is installed correctly.
Install all wires, hoses, and components
carefully so avoid to twisting them together.
Caution
Improper routing may damage leads, hoses or
pipes.
Caution
Kink of brake leads, hose or pipe may reduce
brake performance.
Add specified brake fluid and bleed the system.
This chapter Contents
Master cylinder
Washers
Hose bolt
11. BRAKE SYSTEM
Brake lamp switch
Brake hose
11-9