Disassembly Of Final Driving; Mechanism - Sym Jet 50 Service Manual

Disassembly of Final Driving

Mechanism

Remove driven pulley
Drain gear oil out from gearbox.
Remove rear wheel.
Remove gearbox cover mounting bolts from the
clutch side and then remove the cover from the
rear wheel side.
Remove final gear, final shaft and counter gear,
counter shaft.
Remove the drive shaft from left crankcase.
Caution
The bearing must be replaced when
removing the drive shaft.
Remove drive shaft oil seal and bearing from left
crankcase.
This chapter Contents
8. FINAL DRIVING MECHANISM
Final gear & shaft
Oil seal
Oil filling hole
Oil draining hole
Counter gear & shaft
Drive shaft
Bearing
8-3