Brake System Hose; Type) - Sym Jet 50 Service Manual

2. SERVICE MAINTENANCE INFORMATION
Brake System Hose: (Front Disc
Brake Type)
Make sure that the brake hose is corrosion or
damage, and also check the system for leaking.
Brake Fluid:
Check brake fluid level in the brake fluid
reservoir. If the level is lower than the LOWER
limit, add brake fluid DOT-3 to UPPER limit. Also
check brake system for leaking if low brake level
found.
Caution
In order to maintain brake fluid in the
reservoir in horizontal position, do not
remove the cap until handle bar stop.
Do not operate the brake lever after the cap
had been removed. Otherwise, the brake
fluid will spread out if operated the lever.
Do not mix non-compatible brake fluid
together.
Brake Lining Wear: (Rear Drum Brake

Type)

Replace the brake lining if the wear limit mark
"¡ µ " on the brake arm aligning with the indicator
of brake drum.
Brake Lining Wear: (Front Disc Brake
Type)
The arrow mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
In order to maintain brake power balance, the
brake lining must be replaced with one set.
2-8
This chapter Contents
Lower limit
Arrow
Wear limit mark
Brake lining
Brake caliper
Brake fluid
reservoir cap
Brake disc