Clutch/Driven Pulley - Sym Jet 50 Service Manual

7. "V" TYPE BELT DRIVE SYSTEM/KICK-STARTER

Clutch/Driven Pulley

Disassembly
Remove drive belt and clutch/driven pulley.
Install clutch spring compressor onto the pulley
assembly, and operate the compressor to let nut
be installed more easily.
Caution
Do not press the compressor too much.
Hold the clutch spring compressor onto bench
vise, and then remove mounting nut with clutch
nut wrench.
Release the clutch spring compressor and
remove clutch and spring from driven pulley.
Remove socket from sliding pulley.
Remove guide pin, guide pin roller, and driven
pulley, and then remove O-ring & oil seal seat
from sliding pulley.
Inspection
Clutch outer
Measure the inner diameter of clutch outer
friction face. Replace clutch outer if exceed
service limit.
Service limit: 107.5 mm
7-10
This chapter Contents
Sliding pulley
O-ring
Inner
diameter
Clutch nut
wrench
Clutch spring
compressor
Socket
Oil seal
Guide pin
or
Guide pin roller
Clutch outer