Communication Options - Eaton BladeUPS User Manual

Communication Options

The BladeUPS has serial communication capabilities through the DB−9
communication port or through an X−Slot card in one of the available
bays.
The UPS supports two serial communication devices according to the
following table:
Independent
X−Slot 1
Any X−Slot card
Any X−Slot card
Any X−Slot card
NOTE You can configure relays, signal inputs, and the serial port baud rate through the
front panel menus (see Table 4 on page 74).
NOTE In a UPS connected to utility power, X−Slot cards remain powered on even if the
input breaker is off.
EATON Powerware
X−Slot 2
Any X−Slot card except the
Powerware Modem Card
Powerware Relay Interface Card
Powerware Hot Sync CAN Bridge Card
Not in use
®
BladeUPSt (12 kVA) User's Guide
Multiplexed
DB−9 Communication Port
Not in use
Available
Available
S
164201649 Rev 3 www.powerware.com
COMMUNICATION
91