Key Functions When Powering On; Stop/Eject Key; User2 Key - Dascom T5040 User Manual

Flatbed printer
Hide thumbs Also See for T5040:
Table of Contents

Advertisement

User Guide

Key functions when powering on

STOP/EJECT key

PAPER
USER1
STOP
USER2
SETUP
/EJECT

USER2 key

PAPER
USER1
STOP
USER2
SETUP
/EJECT
Powering on the printer whilst holding the
STOP/EJECT key will activate "Hex
Dump" mode. Keep the STOP pressed until
the message Hex Dump NO PAPER ap-
pears on the LCD display.
Refer to the section
Hex Dump
description of how to activate/deactivate and
perform the test printout.
Powering on the printer whilst holding the
USER2 key, and subsequently loading paper
on instructions from the LCD panel will allow
you to make a status print. This is a print of all
the parameter settings. Keep the USER2 key
pressed until the message Print StatusPage
Load Paper appears on the LCD display.
Refer to the section
Printing out the
, page 55, for further details on the
status page
status page.
Control panel
, page 65, for a
27

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T5040 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF