Table of Contents
Advertisement
User Guide
Configuring the serial
interface of the PC
DOS mode/Command line
Windows 95/98
Windows 2000/XP
To use the serial interface of your PC, you must add the following
mode commands to the AUTOEXEC.BAT file:
mode com1:9600,n,8,1,p
mode lpt1:= com1:
With the first MODE command, you configure the serial interface
Com1 of your PC to the printer's factory defaults. The second MODE
command redirects the parallel standard output port LPT1 of your PC
to Com1.
Transmission rate: 9600 bauds
Parity:
none
Data bits:
8
Stop bits:
1
These settings must be modified to use different values.
Click on the Start button in the Windows taskbar. Move the mouse to
Settings and click on Control Panel. Click on System, followed by
Device Manager. Click on Ports, COM1 and Port Settings.
Bits per second:
9600 bauds
Data bits:
8
Parity:
none
Stop bits:
1
These settings must be modified to use different values.
Click on the Start button in the Windows taskbar. Click on Printers
(Windows 2000) or on Printers and Faxes (Windows XP) to open the
printer folder. In the menu bar, click on File and Server Properties.
Click on Ports, then select COM1 and click on Configure.
Bits per second:
9600 bauds
Data bits:
8
Parity:
none
Stop bits:
1
These settings must be modified to use different values.
Interfaces
133
Advertisement
Table of Contents
Need help?
Do you have a question about the T5040 and is the answer not in the manual?