Customising Your Base Unit; General Points; Emergency Numbers - Binatone e820 System User Manual

Color profile: Generic CMYK printer profile
Composite Default screen

Customising your base unit

General points

You can customise the settings of your e820 base unit,
using a menu which is shown on the handset's display.
Please note that:
If you don't press any button for about 25 seconds,
the handset will time out and the display will return
to standby mode.
When you confirm any setting you have made, you'll
hear a confirmation tone. If you make a mistake,
you'll hear a warning tone.
At the end of each set of steps, you can return the
handset to standby mode by either:
replacing the handset on the base unit
—
pressing and holding the HANG UP/C button
—
Emergency These two numbers can be dialled even when call
numbers barring is set (see page 40).
1 Press the PROG button then 2 2 3 1
2 Key in the first emergency number
3
Press the PHONE/OK button to confirm
4 Press 2 3 2
5
Key in the second emergency number
6
Press the PHONE/OK button to confirm
E:\Binatone2004\e820\e820_UK_03.vp
15 November 2004 11:48:21
39