Remote Operation; To Set A Remote Security Code - Binatone e820 System User Manual

Color profile: Generic CMYK printer profile
Composite Default screen

Remote operation

To set a This is the three-digit code you need if you dial
remote home to check your messages. Unless you set a
security code different code (any three digits), it is 321.
1 Press and hold the CODE button (on the
underside of the base unit) for about 2 seconds
until the machine says 'Set security code' .
Then release the button
2
Press the FORWARD (MEMO) or REWIND
(OGM) button to set the first digit
3
Press the CODE button again
4
Repeat steps 2 and 3 to set the second and
third digits
To check your remote security code
Briefly press the CODE button
To check your 1 Using a tone dialling phone, dial your home number
messages
2 When you hear your outgoing message, press
remotely
u You hear 'Security code' then a 'beep.
3 Key in your remote security code
u You hear one long 'beep'.
4
Press to play back your messages
and/or use the keys listed overleaf
Notes At steps 2, 3 and 4, you must press a key within
10 seconds, or the machine will cut off your call.
At step 3, if you key in the wrong code, you can try
again. You have up to three attempts to get the code
right before the machine cuts off your call.
After about 2½ minutes playback, the machine will
pause and you'll hear a tone (short 'beeps'). To
continue playback, press any key within 10 seconds.
If you don't press a key, your call will be cut off.
E:\Binatone2004\e820\e820_UK_03.vp
15 November 2004 11:48:21
33