Introduction; About Dome Camera; Features - LG LT303 Owner's Manual

Introduction

About Dome Camera

The dome cameras are designed for installation in an
indoor or outdoor video surveillance system.
The camera incorporates the digital signal processor,
pan/tilt mechanism, x27 zoom lens and RS-485 com-
munication interface in a compact outdoor enclosure.

Features

High Sensitivity Support
m
The camera provides the high quality picture with
1/4" EX-view HAD CCD.
Preset Position
m
Preset position is the function to register camera
monitoring positions (preset positions). By using
LKD1000 controller, you can register presets with
position number. Maximum 128 Preset Position
are available. By entering the position numbers,
you can move cameras to the preset positions.
The moving speed and holding time are adjust-
able.
Preset Tour
m
Preset Tour is the function to go through all the
registered camera monitoring positions (preset
positions).
Preset Group Tour
m
A preset tour is composed of a group of preset
positions that the operator can program to be
linked together in a sequence. A preset group
should have a maximum of 8 preset positions.
Pattern recording function
m
A routine of manual operations can be stored and
reproduced repeatedly. The Pan, Tilt and Zoom
controls are available for pattern recording.
Note:
The available total time of pattern differs depend-
ing on camera's operation. When the pattern
recording is full, the pattern recording will auto-
matically stop.
Privacy Mask
m
Privacy zone feature enables users to veil unwant-
ed zones. This setting is used for masking unwant-
ed zones, hiding them from display on the monitor
screen. Up to 8 zones can be registered.
Auto Pan
m
The camera has an Auto Pan function that enables
to keep surveillance on every detail occurring
around the specific area, which is preset to watch
in advance.
The camera can pan among the maximum 8
points you will set. The moving speed and holding
time are adjustable.
Auto Flip
m
When the camera is operated to tilt through the
90°, it can be watched the opposite side of the
locations by Auto Flip of a 180° horizontally.
Optical Zoom
m
The optical zoom range is 1x to 27x.
Digital Zoom
m
Digital zoom enhances the systems zoom range
to 12 times beyond the 27x optical zoom limit. By
utilizing the digital zoom function, the total system
zoom range increases further from 27x (1x digital
zoom) to 324x (12x digital zoom)
Sensor Linkage
m
The camera is capable of capturing a subject by
the focus of camera moving promptly toward the
subject at the rate of 120°/sec when the camera
works with a detector (magnetic, beam, infrared
rays), and a subject moving within a detection area
is captured by a detector.
Alarm In function
m
Alarm input signals are supplied from external
devices through the ALARM IN connector to acti-
vate 'go to preset' function.
Controls by General Controller
m
This camera can be controlled by RS-485.
Especially the camera has an excellent cost-sav-
ing effect because it can be controlled by the gen-
eral RX point of contact signal.
Connects with the maximum 56 cameras
m
This camera can be utilized after being connected
with maximum 256 cameras.
Therefore, it is capable of performing an excellent
job in the large buildings or department stores.
5