Operating Instructions LVC-D200HM/HP/NM/NP LVC-D201HM/HP/NM/NP LVC-D202HM/HP/NM/NP LVC-D203HM/HP/NM/NP LVC-D204HM/HP/NM/NP Before installing and using the camera, please read these instructions thorough- ly and retain them for later reference. P/NO: 3834RS0068R...
Regulatory Notices For U.S.A CAUTION RISK OF ELECTRIC SHOCK This equipment has been tested and found DO NOT OPEN to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, Rules.
1 Safety Precautions Do not attempt to disas- Avoid the camera with semble the camera direct sunlight To prevent electric shock, do not remove Do not aim the camera at bright objects. screws or covers. There are no user Never face it with direct sunlight or other serviceable parts inside.
6 Installation Camera Installation 1. Aim the LG logo of the Dome Camera to face the place that you wish to watch. 2. Tighten the M4 Tapping Screws to fix the Dome Camera on the ceiling, then adjust the Pan (Left / Right) by moving the Pan Base.
7 Installation NOTE When you disassemble the Dome Cover, lift the Dome Cover • Separatory Spring on the opposite side of LG Logo and turn the Dome Cover clockwise simultaneously. Dome Cover Separatory Spring When you install the camera, handle with care. The camera •...
8 Installation Camera Connection Connect the Power Adapter (12V, 300mA; optional) to the Power Input Jack of the camera as shown below. Adapter Power Jack Input Jack Adapter Rear Panel Monitor...
9 Setup 4-pin Dip Switch Setting This camera has the 4-pin Dip Switch inside of the camera for setting. 1. ABL : Auto BLC The default setting is OFF. 2. BLC : Backlight Compensation The default setting is OFF. 3. Y/DC IRIS : When you use Video Lens or DC IRIS Lens The default setting of D200's is DC.
10 Setup Backlight Compensation Setting Backlight compensation eliminates strong background light which makes the camera picture dark such as a spotlight. You can select the mode for adjusting the iris lens. There are two mode as follows. 1. BLC : Set the BLC to ON. The lens iris is manually fixed at the value that you have set regardless of an object.
11 Troubleshooting Check the following guide for the possible cause of a problem before contacting service. The picture is poor • Does the Dome Cover have lots of dust on the surface? Use a dry cloth to clean the camera when it is dirty. Smear may be caused to the screen of night than daytime.