Table of Contents
Advertisement
Configuring the Product
Note:
RSCNs field for this item. The functionality is the same.
4. Click Activate to save and activate the changes. The following message
5. If fabric parameters require configuration, go to
34
e. At the Suppress RSCNs on Zone Set Activations field, choose Enabled
or Disabled. When this parameter is enabled, RSCN messages are
prohibited from being sent to ports on the switch following any change to
the fabric's active zone set. Consult with your HBA and storage device
vendor to determine if enabling this parameter will cause problems with
your HBA or storage products.
Some older versions of EWS may show the Zoning Configuration Change
f.
If you are configuring parameters for the Director 2/64, a Switch Speed
field is displayed. Choose 1 Gb/sec or 2 Gb/sec. These options specify
the speed used on the switch. This field is valid only for the Director 2/64,
which is able to run at both speeds.
displays: Your changes to the operating parameters
configuration have been successfully activated.
Parameters" on page 35. If the configuration is complete, set the product
online as follows:
a. Choose Operations from the navigation panel. The Operations page
displays.
b. Click the Online State tab, then click Set Online. The following message
displays: Your operations changes have been
successfully activated.
"Configuring Fabric
Embedded Web Server User Guide
Advertisement
Table of Contents
