Table of Contents
Advertisement
Table 9: Embedded Web Serve Messages (Continued)
Error 219: Invalid Port
Type
Error 222: Invalid SNMP
Community Index
Error 223: Unknown Error
Error 224: Invalid
Argument
Error 225: Argument
Does Not Contain All
USASCII Characters
Error 226: Argument Is
Too Long
Error 227: Invalid SNMP
Community Name
Embedded Web Server User Guide
Message
The port type configured
is invalid.
The value entered for the
SNMP community index
is invalid.
The switch did not accept
the request
One or more parameters
are invalid for this
command.
The argument contains
non-USASCII characters.
One or more parameters
are invalid for this
command.
The value entered for the
SNMP community name
is invalid
Description
Error Messages
Action
A port may be configured
to be an eport, gport, or
fport. Be sure the port is
configured appropriately
and resubmit the
command. On the Edge
Switch 2/24 only, fxport
and gxport types are also
supported.
The SNMP community
index must be an integer
in the range 1–6. Make
the appropriate changes
and resubmit the
command.
Contact your service
representative.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
The community name
must not exceed 32
characters in length.
Duplicate community
names are allowed, but
corresponding write
authorizations must
match. Enter an
appropriate SNMP
community name and
resubmit.
133
Advertisement
Table of Contents
