HP AA-RTDRB-TE User Manual page 125

Table 9: Embedded Web Serve Messages (Continued)
Error 79: FRU Failed
Error 81: Default Zone
Enabled
Error 82: Invalid Interop
Mode
Error 83: Not Allowed in
Open Fabric Mode
Error 88: Invalid Feature
Key Length
Error 89: Not Allowed in
S/390 Mode Without the
SANtegrity Feature
Error 90: Invalid Port Type
Embedded Web Server User Guide
Message
The specified FRU has
failed.
The request cannot be
completed because the
default zone is enabled
The value entered for the
interoperability mode is
not valid.
This request cannot be
completed while this
switch is operating in
Open Fabric 1.0 mode.
The feature key installed is
longer than the maximum
length allowed.
Cannot configure port
types in S/390 mode
(FICON management
style in HAFM) without
installing SANtegrity.
The port type configured
is invalid.
Description
Error Messages
Action
Consult the
installation/service
manual for appropriate
action.
Disable the default zone
and resubmit the
command.
The interoperability mode
for the director or switch
must be mcdata
(Homogenous Fabric) or
open (Open Fabric 1.0).
Make the appropriate
changes and resubmit the
command.
Configure the interop
mode to Homogenous
Fabric mode.
Be sure that the key has
been entered correctly
and resubmit. Contact
your sales representative
with any further problems.
This command is only
supported when the
switch is in Open Systems
mode (Open Systems
management style in
HAFM) or in S/390
mode (FICON
management style in
HAFM) with SANtegrity.
A port may be configured
to be an eport, gport, or
fport. Be sure the port is
configured appropriately
and resubmit the
command.
125