Table of Contents
Advertisement
3. Click Activate to save and activate the changes. The following message
4. If the product is offline, set the product online as follows:
Configuring Product Identification
Perform this procedure to configure the HP product's name, description, location,
and contact person. The Name, Location, and Contact variables configured here
correspond respectively to the variables used by SNMP management workstations
when obtaining data from managed edge switches or directors. To configure
identification:
1. Choose Configure from the navigation panel. Choose the Switch or Director
Figure 5: Configure product Identification tab view
Embedded Web Server User Guide
displays: Your changes to the port configuration have
been successfully activated.
a. Choose Operations from the navigation panel. The Operations page
displays.
b. Click the Online State tab, then click Set Online. The following message
message displays: Your operations changes have been
successfully activated.
tab, as appropriate. The Switch or Director tab displays with the
Identification tab view
(Figure
5).
Configuring the Product
29
Advertisement
Table of Contents
