Making Dsn Analysis Measurements - HP OMNIBER 718 37718A User Manual

Description
HOW TO:
Making Measurements

Making DSn Analysis Measurements

Making DSn Analysis Measurements
G.821, G.826, M.2100, M.2110 and M.2120 analysis results are provided
for all relevant DSn and DSn Payload error sources.
In addition the following results are provided:
Cumulative error count and error ratio
Short Term error count and error ratio
Alarm Seconds
SIG/BIT Monitor. See "Monitoring Signaling Bits " page 76.
1 If SONET is chosen as the interface, set up the Receive Interface and
Payload required. See "Setting SONET Receive Interface " page 17. If
required set up the Transmit Interface and Payload. See "Setting
SONET Transmit Interface " page 4.
2 If DSn is chosen as the interface, set up the DSn receive interface. See
"Setting DSn Receive Interface " page 15. If required set up the DSn
transmit interface. See "Setting DSn Transmit Interface " page 2.
3 Press
RUN/STOP
4 If SONET is chosen as the interface, you can view the analysis results
on the
RESULTS
If DSn is chosen as the interface, you can view the analysis results on
the
DSn
RESULTS
to start the measurement.
DSn PAYLOAD ERROR ANALYSIS
ERROR ANALYSIS
display
display.
71