HP OMNIBER 718 37718A User Manual page 105

HOW TO:
N OT E
Making Measurements
Measuring Jitter Transfer
Start the Jitter Transfer Measurement
The Jitter Transfer measurement must be started within 10 minutes of
the completion of calibration.
1 After the CALIBRATION is completed, remove the back to back
connection from the DSn or SONET or optical interfaces.
If the measurement is to be made at a network equipment monitor
point, choose
MONITOR
before making the jitter transfer measurement.
2 Choose MODE
MEASURE
press
RUN/STOP
The measurement's progress can be monitored on the
display. At the end of the test the graph can be viewed on the
display.
JITTER
on the DSn or SONET
on the
TRANSMIT
.
display
RECEIVE
display and
JITTER
TRANSMIT
RESULTS
95