Table of Contents
Advertisement
Description
HOW TO:
Selecting Test Features
Using FEAC Codes
Using FEAC Codes
The third C-Bit in subframe 1 is used as a FEAC channel, where alarm
or status information from the far-end terminal can be sent back to the
near-end terminal. The channel is also used to initiate DS3 and DS1 line
loopbacks at the far-end terminal from the near-end terminal.
The codes are six digits long and are embedded in a 16 bit code word; the
format is 0XXXXXX011111111.
There are two types of code, Loopback and Alarm Status.
Loopback provides a choice of two DS1 messages and two DS3 Messages.
The DS1 Messages can be sent in ALL DS1 channels or in a SINGLE
channel. The message can be repeated up to 15 times.
Alarm Status provides 13 preset codes and a USER programmable code
function. These codes can be transmitted continuously or in bursts.
The new code is transmitted by choosing
Transmit an FEAC code
1 Choose SIGNAL
MAIN SETTINGS
2 Choose
TRANSMIT
When a FEAC code is not being transmitted, an all ones pattern is
transmitted.
and PAYLOAD TYPE
DS3
display.
and ALARM TYPE
TEST FUNCTION
or
BURST
ON
.
on the
CBIT
TRANSMIT
DS3 FEAC
.
51
Hide quick links:
Advertisement
Table of Contents
