HP OMNIBER 718 37718A User Manual page 24

Setting the Interfaces
Using Smart Test
4 In SONET mode the incoming signal will be identified on the top line
of the display, and under this the payload mappings, the J1 Trace and
C2 byte indicators are displayed on the bottom lines
5 Use the and
STS SPE. When the STS SPE of interest has been identified choose
either
VIEW PAYLOAD
6 Choosing
VIEW PAYLOAD
mapping of the TUG structured signal, as shown below.
Choose the required tributary using
7 There are four choices available at this point:
which sets the receiver to receive the selected tributary.
SETUP RX
TROUBLE SCAN
tributary, exits to the
gating.
VIEW LABELS
the selected tributary.
which returns the display to the STS SPE selection
TOP LEVEL
window.
8 Choosing
PRBS SEARCH
information about patterns and which mapping to search. When the
required data has been entered press
9 When the search is complete a tributary display appears, with any
tributaries containing the required PRBS indicated with a "P". Choose
the required tributary using
14
keys to display the J1 Trace information for each
or
PRBS SEARCH
will identify and display the payload
which sets the receiver to receive the selected
TROUBLE SCAN
RESULTS
which displays the C2/V5/J1/J2 trace information for
at Step 5 will prompt you for additional
and
.
.
and .
display and starts
.
GO
.