Irda Communication - Denso BHT-604BW User Manual

3.5.2 IrDA Communication

 When performing data communication between BHT units
Point the BHT IrDA communication ports toward each other and perform communication.
Requests
 Make sure that the light path between the BHT and any target stations is not obstructed.
 Perform communication within the effective IrDA emission range (15 cm).
 Do not operate remote control units for televisions and so forth in the vicinity of IrDA communication.
This may result in comunication failure.
 Perform communication in locations where the BHT units will not be exposed to light interference from
sources such as intence ambient lighting (inverter-driven fluorescent lighting, in particular) or direct
sunlight. This may result in comunication failure.

When performing data communication with the host computer
Data can be transmitted directly to the host computer if the computer is equipped with an IrDA
communication port.
If the host computer is not equipped with an IrDA communication port, place the BHT on the
communication unit (CU-601, CU-621 or CU-611) and transmit data.
In case of using the CU-601 or CU-621, the BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC
4.0 Transfer Utility (Option) software is required.
In case of using the CU-611, FTP communication environment is required.
CU-601: RS232C
CU-621: USB
CU-611: Ethernet
Barcode Handy Terminal
35