Initiating A Multitalker Network - Phonak inspiro Premium User Manual

15.2 Initiating a MultiTalker Network

Initiating or setting up a MultiTalker Network should be
performed in the classroom before the lesson begins. The
procedure to follow is straightforward and the inspiro
menu guides you through the necessary steps. See the chapter
"Switching ON DynaMic" on page 52.
J Make sure you have all the inspiro and DynaMic transmitters
you plan to include in the network in front of you on the desk.
Ensure all these transmitters are switched OFF.
J Take the main teacher's or main speaker's inspiro and switch
it on. In this inspiro, select MultiTalker Network and then Set
up network. This inspiro is known as the "initiator".
J Read the information on the LCD display and then press the
Start soft key.
J Next, switch on all of the other inspiro and DynaMic
transmitters.
J A list of the inspiro and DynaMic transmitters that have
joined the network should now be displayed on the initiating
inspiro. If all of the transmitters are listed, press the Continue
soft key.
You have successfully created a MultiTalker Network! All inspiro
and DynaMic transmitters are paired by the initiator inspiro.
Begin talking as usual.
57