Installing The Radio System - Hangar 9 P-51 Mustang ARF Instruction Manual

Section 14

Installing the Radio System

Step 4. Install the elevator and rudder servos by feeding the
servo lead and extensions through the fuselage. Secure the
servos using the screws supplied with your radio system.
Hint: Use masking tape to identify the elevator
and rudder servo leads.
Step 5. Using thick CA, glue in the plywood servo tray, oriented
as shown. Note the throttle servo opening should be towards the
side of the fuselage where the pushrod tube is located.
Step 6. Temporarily install the throttle servo as shown with the
output shaft to the side of the fuselage where the pushrod is
located. Mark the mounting screw hole locations with a felt-
tipped pen or pencil.
Step 7. Remove the throttle servo and drill the screw holes you
just marked with a 1/16" drill bit.
Step 8. Mount the throttle servo using the screws provided with
your radio system. The throttle linkage will be installed later in
this manual.
CONTINUED
39