Hangar 9 P-51 Mustang ARF Instruction Manual page 30

Section 10
Installing the Rudder and Tail Wheel Assembly
Step 5. Align the tail wheel assembly bracket with the center of
the fuselage and drill the screw mounting holes using a 1/16"
drill bit. Using the two provided screws, mount the bracket to the
fuselage as shown.
Step 6. Install the rudder hinges placing a T-pin through the
center of each hinge to keep it centered while installing
the rudder.
30
Step 7. Mix at least 1/4 ounce of 6-minute epoxy and use a
tooth pick to coat the inside of the hole you drilled in the rudder.
Also coat the wire that inserts into the rudder. Use caution not to
get epoxy into the tail wheel assembly bushing.
Step 8. Install the rudder and wipe away excess epoxy using
rubbing alcohol and paper towels. Remove the T-pins and move
the rudder against fin until there is only a slight gap (1/32" or
less). Use masking tape to secure the rudder to the fin and allow
the epoxy to cure.
CONTINUED