Hangar 9 P-51 Mustang ARF Instruction Manual page 45

Section 17
Application of Decals and Scale Detailing
Step 1. Using a pair of canopy scissors, cut out and trim the
cockpit and exhaust detail.
Step 2. Using the detail drawings, glue the cockpit detail to the
fuselage using Shoe Goo or similar type adhesive. Secure the
parts with tape until the glue has dried.
Step 3. Using the drawings, locate the position of the scale
exhaust. It will be necessary to cut the exhaust pieces and glue
one part to the fuselage and the other to the cowl. If necessary,
cut an access hole for the cowl mounting screw before gluing on
the exhaust.
Step 4. Locate the decal sheet and cut out the decals for the
P-51 using a sharp hobby knife and scissors.
Step 5. Use the drawings to locate the position of the decals on
the P-51. Use a water spray bottle with 2-3 drops of dish soap
added to the water and spray both the fuselage and sticky side of
the decal. This will allow you to reposition the decal if necessary.
Once satisfied with the position use a paper towel to squeegee
out the water. Allow the decal to dry over night.
Note: There may be some clouding under the decal,
but this will go away as the decal dries.
CONTINUED
45