Stage 2-Installing The Radio - Hangar 9 Advance 40 Instruction Manual

Stage 2—Installing the Radio
Parts and Supplies Needed
• Fuselage with pushrods and tank pre-installed
• Shock-Loc radio tray with six self-tapping screws
• Three servos with rubber grommets (12).
Note: The eyelets and servo screws included with the
radio will not be used
• Receiver (included with radio system)
• Battery pack (included with radio system)
Step 1. Prepare the remaining three servos by installing the
rubber grommets, four on each servo.
Note: Do not install the brass eyelets. The Shock-Loc radio
tray is designed to capture the servos by the rubber
grommets and the eyelets are not needed.
• Switch harness (included with radio system)
• Aileron extension (additional part required)
• Medium rubber bands (2)
• Double-sided servo tape (2 pieces)
• Masking tape (optional)
• Pen (optional)
• Phillips screwdriver
Hint: It's helpful to mark the servo wires so they can be easily
identified when it's time to install them in the receiver. A piece of
masking tape near the connector with the appropriate letter
(T=throttle, E=elevator, R=rudder) written on it will save time later
during the radio hook up.
11