Hangar 9 P-51 Mustang ARF Instruction Manual page 16

Section 5
Installing the Retract Servo
Step 4. Trail fit the retract servo and mounting plate to the
retract servo rails temporarily installed in the wing assembly.
Position the servo output shaft as close to the center of the wing
as shown. Mark the location of the plate on the servo rails using
a felt-tipped pen or pencil. Remove the retract servo and plate
assembly and also remove the rails from the wing noting the
orientation of the rails in the wing.
Step 5. Remove the retract servo from the mounting plate.
Use thick CA and carefully glue the retract servo mounting
plate to the servo rails. Align the plate with the marks you made
on the rails. Allow the CA to fully dry before mounting to the
wing assembly.
Step 6. Mix approximately 1/2 ounce of 6-minute epoxy and
carefully glue in the retract servo mount assembly to the
wing assembly. Be sure to position the rails with the proper
orientation as noted in the previous step. Allow the epoxy to cure
completely before proceeding to the next step.
16
Step 6 photo
Step 7. Permanently mount the retract servo to the mounting
plate using the screws provided with your retract servo.
Step 8. If you have not already done so, remove the servo
wheel from the servo. Locate the two quick connects supplied in
the kit and mount them to the servo wheel as shown.
CONTINUED