Adjusting The Height Of The Foot Plate; Adjusting The Height Of The Legrests; Positioning The Calf Pad; Electrically Height-Adjustable Legrests - Ortopedia TOURING 926 Operating Manual

5.5.5.4 Adjusting the height of
the legrests
You raise the legrest by simply pulling it
up to the desired height. To lower the
legrest, hold the legrest and then press
down the lever (Fig. 63/ ).

5.5.5.5 Positioning the calf pad

To adjust the height, slacken the se-
curing screw (Fig. 64/ ), move the calf
pad up or down to the desired position
and then retighten the securing screw.
To adjust the depth, (thin or thick calf)
slacken the securing screws (Fig. 64/
move the calf pad forwards or rearwards
to the desired position and then
retighten the securing screws.
38
63
),
64
5.5.6 Electrically height-adjust-
able legrests
See the 'Operating Manual for Control
Units' for information on how to adjust
1
the electrically height-adjustable legrests.

5.5.6.1 Detaching the legrests

Pull down the locking knob (Fig. 64.1/
) and then pull off the legrest.
The contacts will separate automatically.

5.5.6.2 Hanging in the legrests

3
Insert the mount of each legrest into the
respective tube until it latches. The elec-
trical contacts will make automatically. –
2
Check for the correct functioning of the
locking device!
5.5.6.3 Adjusting the height of
the foot plate
Hold the foot plate and then unscrew
the clamping screw (Fig. 64.2/ ) by
about ½ a turn.
Move the foot plate to the desired height
and then tighten the clamping screw.
Attention:
!
The marking (crease) shows the
maximum extension.
5.5.6.4 Adjusting the height of
the foot plate
The calf plate can be fixed at one of
three different depth positions after the
securing screw (Fig. 64.2/
removed.
1
64.1
64.2
) has been
3
2
39