Removal Of Leg Supports; Attachment Of Leg Supports; Height-Adjustment Of Foot Plates (774-1); Height-Adjustment Of Foot Plates (774-2 Al) - Ortopedia Impuls ORTOform Operating Manual

3.2.6.5 Removal of leg supports

The leg supports can be detached in an
upward direction (fig. 26/ ) by press-
ing the respective lever for locking the
leg support (fig. 27), and then swivel-
ling away the leg support (fig. 28).
3.2.6.6 Attachment of leg sup-
ports
Insert leg supports from above at an
angle into the leg support holders (fig.
29), and swivel supports forwards until
you hear them click into place.
Attention:
!
Do not forget to check the correct
functioning of the respective locking
device (fig. 26/ ) after having swiv-
elled in the legrests again.
26
1
26
27
28
29
3.2.6.7 Height-adjustment of
foot plates (774-1)
The foot plate can be telescoped in steps
to the desired height after the removal
of the locking screw (fig. 30/ ).
Note:
Fit the locking screw at the appro-
priate height and then tighten.
The tightening torque is 5 Nm.
3.2.6.8 Height-adjustment of
foot plates (774-2 AL)
The foot plate can be infinitely telescoped
to the desired height after the removal
of the locking screw (fig. 31/ ).
Note:
Observe markings indicating maxi-
mum extension.
Re-tighten screw.
The tightening torque is 5 Nm.
1
30
1
31
27