Components; Seat; Seat Cushion; Adjusting The Seat Depth - Ortopedia TOURING 926 Operating Manual

5. Components

5.1 Seat

5.1.1 Seat cushion

The standard seat cushion (Fig. 31) is
secured to the seat plate with Velcro fas-
teners and can be pulled off.
The ERGOpor seat cushion (Fig. 32/
is secured to the seat shell with Velcro
fasteners and can be pulled off.

5.1.2 Adjusting the seat depth

The seat depth can be changed by
moving the backrest to a different posi-
tion.
Note:
The attaching must be carried out by
an authorised dealer.
The securing screws (Fig. 33/ ) must
be removed to reposition the backreast.
Then remove the spacer sleeves from
the holes and insert them into the holes
for the new position of the backrest
mount. Attach the backrest mount with
the securing screws.
26
31
)
1
32
1
33

5.1.3 Swivelling up the seat

The seat must be swivelled up to the rear
for maintenance work and for access to
the batteries and the fuses.
Attention:
!
– Park the wheelchair on a level sur-
face and move the selection lever
into the drive mode position.
– Drive down the electrically-oper-
ated seat-angle adjusting device.
– Switch off the control unit and then
2
pull out the security plug.
– Detach the legrests.
– Bring the backrest into the upright
position.
– Remove the backrest strap. (Only
necessary if the backrest is attached
at the rear screw-on position).
Press down the lever (Fig. 38/
the seat up to the end stop!

5.1.4 Swivelling down the seat

Attention:
!
Carefully swivel down the seat.
– Danger of squashing between the
seat and the chassis/covers.
2
38
2
38
). Swivel
Swivel the seat down onto its mount in
a controlled manner by holding with
one hand on the adjusting element (see
Fig. 38/ which shows the electric ver-
sion). Press on the front edge of the seat
with the other hand until the locking
)
device (Fig. 38/ latches.
1
27