Detaching The Control Unit; Attaching The Control Unit; Swivelling The Control Unit To The Side; Loading And Transport - Ortopedia TOURING 926 Operating Manual

4.7.3 Detaching the control
unit
Open the cable clip (Fig. 24/ ) and
slacken the clamping screw (Fig. 23/
). Push the control unit to the rear.
Slacken the clamping screw (Fig. 23/
and pull off the entire armrest unit in
an upward direction.
The control unit can now be pulled out
to the front. Carefully route the cable
when moving the control unit. Retighten
the clamping screw.

4.7.4 Attaching the control unit

Insert the control unit into its clamping
device. Mount the entire armrest unit
and secure with the clamping screw.
Correctly route the connecting cable
again. Tighten the clamping screw (Fig.
23/ ) after having positioned the con-
trol unit.
22
)
22
1
3
23
4.7.5 Swivelling the control unit
to the side
The control unit can be swivelled to the
side into a position where it is parallel to
the armrest (Fig. 24.1). This makes it
possible to, for example, drive closer to
a table. For normal driving, swivel the
control unit forward again over the pres-
sure point until it latches into place.
4.8 Loading and trans-
port

4.8.1 Safety information

For the transport in vehicles, you must
leave the wheelchair and sit in a suit-
able seat in the vehicle. – The wheel-
chair is not designed to withstand the
forces which are generated in accidents,
which exposes the user to considerable
risks.
Attention:
!
– Observe the 'Safety information for
electric vehicles' .
24.1
23