Height Adjustment; Detaching The Armrest; Clothing Protector; Legrests - Ortopedia TOURING 926 Operating Manual

5.3.2 Height adjustment

Tools:
1 x 13 mm open-end or ring spanner
Slacken the securing screw (Fig. 52/
, bring the backrest into the desired
vertical position and then retighten the
securing screw.
Attention:
!
Hold the armrest with one hand in
order to stop it falling. - Danger of
squashing.

5.3.3 Detaching the armrest

Slacken the clamping lever (Fig. 53/
and pull off the armrest in an upward
direction.
Note:
The control unit must be detached
first if the armrest on the control side
is to be detached. To do this, open
the cable clip (Fig. 54/ ) and
slacken the securing screw (Fig. 53/
). Push the control unit to the rear.
Slacken the clamping screw (Fig. 53/
) and pull off the entire armrest
unit in an upward direction.
34
)
3
52
1
)
3
53
4
54
The control unit can now be pulled out
to the front. Carefully route the cable
when moving the control unit. Retighten
the clamping screw.
WW* = Wrench width (mm)

5.4 Clothing protector

The clothing protector can be horizon-
tally displaced. You do this by slacken-
ing the securing screws (Fig 55/
Bringing the clothing protector to the
desired position and then retightening
the securing screws.

5.5 Legrests

Various legrest models for the wheel-
chair are available. The foot plates can
be folded up to the side.
2
Attention:
!
– Do not use the legrests to lift or
carry the wheelchair.
– Always place the feet on the foot
plates before a wheelchair motion!
5
).
55
35