Detaching The 30° Backrest; Attaching The 30° Backrest; Detaching The Backrest Element; Attaching The Backrest Element - Ortopedia TOURING 926 Operating Manual

5.2.4.1 Detaching the backrest
element
Pull the upper holders off the backrest
frame (Fig. 48) and then lift off the
backrest element in an upward direc-
tion.
5.2.4.2 Attaching the backrest
element
Place the lateral guides onto the pins
(Fig. 49/ ) and then press the upper
holders of the backrest element onto the
frame at the left and right side.
5.2.4.3 Folding down the electric
backrest
The backrest can be folded down to the
front for storage or transport. Press
down the U-shaped bar (Fig. 50/
and then fold down the backrest to the
front.
5.2.4.4 Folding up the electric
backrest
Pull on the push bar to bring the backrest
into the upright position and then pull
to the rear with a jerk so that the lock-
ing device audibly latches. – Check for
the correct functioning of the locking
device!
32
48
49
)
2
50

5.3 Armrests

The armrests can be adjusted in height
and depth to suit the needs of the user.
Attention:
!
Do not use the armrests to lift or carry
the wheelchair.
Do not drive without the armrests!
5.3.1 Adjusting to suit the seat
depth
Tools:
1 x 13 mm open-end or ring spanner
Slacken the securing screw (Fig. 51/
1
bring the armrest into the desired hori-
zontal position and then retighten the
securing screw.
Note:
Slacken the securing screw (Fig. 51/
) to adjust the depth of the control
unit. Retighten the securing screw
after the depth adjustment.
SW* = Schlüsselweite (mm)
1 2
51
),
33