Table of Contents
Advertisement
5.4 Clothing protector
The clothing protector can be horizon-
tally displaced. You do this by slacken-
ing the securing screws (Fig 44/
Bringing the clothing protector to the
desired position and then retightening
the securing screws.
5.5 Legrests
Various legrest models for the wheel-
chair are available. The foot plates can
be folded up to the side.
Attention:
!
– Do not use the legrests to lift or
carry the wheelchair.
– Always place the feet on the foot
plates before a wheelchair motion!
36
5
).
44
5.5.1 Calf strap
The calf strap is hooked into the holders
of the legrests on the left and right side
(Fig. 45/
).
5.5.2 Detaching the legrests
Detach the calf strap. Pull the locking
device (Fig. 46/
) outwards. Swivel out
the legrest and then pull it off in an
upward direction.
5.5.6 Hanging in the legrests
With the legrest in a swivelled-out posi-
tion, hang-in the legrest (Fig. 47) and
then swivel it to the front until the lock-
ing device audibly latches. – Check for
the correct functioning of the locking
device! Attach the calf strap.
5.5.7 Adjusting the height of
the foot plate
Hold the foot plate and then unscrew
the clamping screw (Fig. 48/
about ½ a turn.
Move the foot plate to the desired height
and then tighten the clamping screw.
Attention:
The marking shows the maximum
!
extension.
1
45
1
46
) by
47
2
48
37
Hide quick links:
Advertisement
Table of Contents
