Table of Contents
Advertisement
3.2.7 Upholstered backrest
The upholstered backrest must be de-
tached for folding (fig. 38).
3.2.7.1 Detaching the uphol-
stered backrest
Slacken the wing nut and then slide the
securing clip inward (fig. 39).
Then take off the upholstered backrest
in a forward direction by pressing lightly.
3.2.7.2 Attaching the uphol-
stered backrest
The upholstered backrest is attached by
pressing the clips of the upholstered
backrest onto the backrest tubes (fig. 40
and 41). The upholstered backrest is se-
cured by sliding the lower securing clips
outward and then tightening the wing
nuts (fig. 41).
30
38
39
40
41
3.2.8 Upholstered seat
The upholstered seat must be detached
in an upward direction for folding (fig.
42).
To attach the upholstered seat, align it
according to the adjusted depth and the
clearance space of the upholstered seat
and the crossbrace (fig. 43).
Note:
The seat clips rest on the seat tubes.
The seat can be secured by screw-
ing an M5 x 30 mm cross-recessed
screw into each of the front seat clips
(fig. 43.1).
42
43
43.1
31
Advertisement
Table of Contents
