Table of Contents
Advertisement
4.7.3 Detaching the control
unit
Open the cable clip and slacken the
clamping screw (Fig. 15/
). Push the
control unit to the rear. Slacken the
clamping screw (Fig. 15/
) and pull
off the entire armrest unit in an upward
direction.
The control unit can now be pulled out
to the front. Carefully route the cable
when moving the control unit. Retight-
en the clamping screw.
4.7.4 Attaching the control unit
Insert the control unit into its clamping
device. Mount the entire armrest unit
and secure with the clamping screw.
Correctly route the connecting cable
again. Tighten the clamping screw (Fig.
15/
) after having positioned the con-
trol unit.
20
14
1
2
15
4.7.5 Swivelling the control unit
to the side
The control unit can be swivelled to the
side into a position where it is parallel to
the armrest (Fig. 16). This makes it pos-
sible to, for example, drive closer to a
table. For normal driving, swivel the
control unit forward again over the pres-
sure point until it latches into place.
4.8 Loading and trans-
port
4.8.1 Safety information
For the transport in vehicles, you must
leave the wheelchair and sit in a suita-
ble seat in the vehicle. – The wheelchair
is not designed to withstand the forces
which are generated in accidents, which
exposes the user to considerable risks.
Attention:
– Observe the 'Safety information for
!
electric vehicles' .
16
21
Hide quick links:
Advertisement
Table of Contents
