Table of Contents
Advertisement
4. Components
4.1 Armrests
Attention:
!
Do not use wheelchair without arm-
rests guards fitted.
Do not use the armrests to lift or car-
ry the wheelchair.
4.1.1 Adjustment of the seat
width
The seat width can be adjusted by a lat-
eral displacement of the armrests. After
loosening the clamping screws (fig. 6 /
) on both sides adjust the armrests on
both sides by the same length.
Attention:
The maximum seat width has been
!
reached when a marking is visible
on the square tube.
The retrofit may only be carried out
by an authorised dealer!
4.1.2 Detaching the armrest
Slacken the clamping screw (fig. 7/
and pull off the armrest upwards.
10
1
6
2
7
)
4.1.3 Armrest height adjustment
For the height adjustment of the arm-
rest first loosen the clamping screw (fig.
8/
) of the height stopper.
Then slacken the clamping screw (fig.
8/
).
Attention:
Hold the armrest with one hand in
!
order to stop it falling. – Danger of
crushing!
Slide the armrest to the desired height
and tighten the clamping screw (fig. 8/
). Afterward push the height topper
down and tighten the clamping screw
fig. 8/1.
Attention:
The maximum armrest height has
!
been reached when the marking on
the square tube is visible.
The stopper serves to find the adjusted
height position again when the armrest
is removed.
4.1.4 Depth adjustable side ele-
ment
The side element can be adjusted in
depth. Regarding this, loosen the four
screws (fig. 8/
) and adjust the side
element to the desired depth, then
tighten the four screws (fig. 8/ ) again.
3
3
1
2
8
11
Advertisement
Table of Contents
