Vertical - Interior; Through The Wall & Vertical - External; Vertical Into Existing Class A Chimney - Quadra-Fire SANTAFE-MBK Owner's Manual

Santa Fe Pellet Stove
B. Vertical - Interior - Typical Installation
PREFERRED METHOD #1
Flashing
Firestop
6 in.
(152mm)
Min.
Non-combustible Hearth Pad
Figure 15.1
D. Vertical into Existing Class A Chimney
Flashing
Firestop
Ceiling Support
6 in.
(152mm)
Minimum.
Non-combustible Hearth Pad
Figure 15.3
May 12, 2014
Rain Cap
12 in.
(305mm)
Minimum
3 in. (76mm) Min.
3 in. to 3 in.
(76-76mm)
Top Vent Kit
Clean-out Cover
on other side
Rain Cap
12 in. (305mm) Minimum
6 in. (152mm) Class A
Chimney Connector
Adapter
3 in. (76mm) Minimum.
6 in. (152mm) Flue
Connector
3 in. to 6 in.
(76-152mm)
Top Vent Kit
Cleanout Cover
7050-128G
C. Through The Wall & Vertical - External
PREFERRED METHOD #2
2 in. (51mm) minimum
6 in. (152mm)
Minimum
Figure 15.2
We strongly recommend a minimum of 60
inches (1.5m) vertical, however above the
eave is preferred.
Both installations are approved for mobile home
installations. Must use 3 or 4 inch (76 to 102mm)
"L" or "PL" Listed pellet venting or Listed double
wall pipe and Quadra-Fire Outside Air Kit in mobile
homes. Single wall pipe is approved for residential
installations only.
Air Clearance to Pipe
This appliance was tested with standard 3 inch
(76mm) Listed pellet clearance pipe to combustibles.
Pellet pipe manufactures Listed reduce clearance
pipe may be use for reduce clearance from 3 inch
(76mm) air clearance to no less than 1 inch (25mm)
air clearance to combustibles for approved Listed
pellet pipe.
Follow stove pipe manufactures listed air clearances
to combustibles and installation instructions for all
reduced air clearances installations.
Rain Cap
24 in.
Flashing
(610mm)
Minimum
Support
Bracket
every 60 in.
(1.5m)
Wall Thimble
Tee
Clean-out Cover
Non-combustible Hearth Pad
:
Page 15
R