Glass Replacement; Broken/Damaged Component - Quadra-Fire SANTAFE-MBK Owner's Manual

Santa Fe Pellet Stove
J. Glass Replacement
WARNING
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
1. Open the face and remove door from the appliance by
lifting door off of hinge pin and lay on a fl at surface face
down.
2. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the rod
will slide up. Swing the rod toward you from the bottom
and remove the rod. Repeat for other side.
3. Remove old glass and replace with new glass.
4. Slide the retainer rod into the top hole fi rst, and then line
up the bottom crimped end with the hole in the door. The
crimped end must be paralle with the glass in order to
insert it into place. Figure 39.1.
Rope Retainer
Glass
Figure 39.1
May 12, 2014
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
K. Damaged/Broken Component
Replacement
1. Replacement of broken or damaged components
should only be completed by a trained or qualifi ed
technician.
2. In the event that you fi nd a damaged component,
please contact your local dealer, to send a service
technician to complete the removal and replacement
of the parts.
7050-128G
R
Page 39