Igniter Replacement; Baffl E & Brick Removal - Quadra-Fire SANTAFE-MBK Owner's Manual

Santa Fe Pellet Stove
G. Igniter Replacement
Firepot
Figure 37.1
1. Shut down the appliance by turning down the thermostat
and let the appliance completely cool down. After the
appliance has cooled down, unplug it and remove the
ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections and remove the
igniter from the chamber. Loosen thumb screw and
slide igniter out.
3. Install new igniter into the chamber and tighten thumb
screw. Re-connect the wires to the 2 leads with the
spade connectors.
4. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod,
cleaning slide plates, etc.
5. Re-install the ash drawer and side panel and re-connect
the power.
May 12, 2014
Igniter
Thumb Screw
H. Baffl e & Brick Set Removal
1. Follow proper shutdown procedures in Section 10.
2. The top baffl e has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffl e by fi rst pulling the baffl e forward
until back edge drops down. Then slide baffl e back until
the front edge clears the shelf that it had been resting on.
Figure 37.2.
3. The top baffl e must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is fl ush with the fi rebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick. Figure 37.3.
Figure 37.2
Remove Right
& Left Brick
Figure 37.3
Exhaust Area
Figure 37.4
7050-128G
Hook on
Tab on
left side
right side
Right Brick
Removed
Vacuum
R
Page 37