Quadra-Fire SANTAFE-MBK Installation Manual
  1. Manuals
  2. Brands
  3. Quadra-Fire Manuals
  4. Pellet stove
  5. SANTAFE-MBK
  6. Installation manual

Quadra-Fire SANTAFE-MBK Installation Manual

Santa fe pellet appliance
Hide thumbs Also See for SANTAFE-MBK:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual, Owner's Manual Installation and Operation
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
SANTA FE PELLET APPLIANCE
MODEL: SANTAFE-MBK
CAUTION
Check building codes prior to installation.
•
Installation MUST comply with local, regional, state
and national codes and regulations.
•
Consult local building, fire officials or authorities
having jurisdiction about restrictions, installation
inspection, and permits.
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
1
Installation Manual
Installation & Appliance Set-Up
NOTICE: DO NOT DISCARD THIS MANUAL
If the information in these instructions is
not followed exactly, a fire could result
causing property damage, personal
injury, or death.
•
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
•
Do not over fire - If appliance or chimney connector
glows, you are over firing. Over firing will void your
warranty.
•
Comply with all minimum clearances to combustibles
as specified. Failure to comply may cause house fire.
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
•
Do not touch glass until it is cooled
•
NEVER allow children to touch glass
•
Keep children away
•
CAREFULLY SUPERVISE children in same room as
fireplace.
•
Alert children and adults to hazards of high
temperatures
•
High temperatures may ignite clothing or other
flammable materials.
•
Keep clothing, furniture, draperies and other
flammable materials away.
Tested and approved for wood pellets and shelled corn
only. Burning of any other type of fuel voids your warranty.
To obtain a French translation of this manual, please contact
your dealer or visit
Pour obtenir une traduction française de ce manuel, s'il vous
plaît contacter votre revendeur ou visitez
7050-145L
WARNING
WARNING
CAUTION
NOTE
www.quadrafire.com
www.quadrafire.com
August 3, 2018

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SANTAFE-MBK and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Quadra-Fire SANTAFE-MBK

Summary of Contents for Quadra-Fire SANTAFE-MBK

  • Page 1 SANTA FE PELLET APPLIANCE causing property damage, personal injury, or death. MODEL: SANTAFE-MBK • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

  • Page 2: Table Of Contents

    G. Equivalent Feet of Pipe ....16 H. Pipe Selection Chart ..... . 17 Quadra-Fire is a registered trademark of Hearth & Home Technologies. 7050-145L...

  • Page 3: Important Safety Information

    NOTICE: This installation must conform with local codes. In the absence of local codes you must comply with the ASTM E1509-04, ULC S627-00, (UM) 84-HUD and ULC/ORD-C-1482. The Quadra-Fire Santa Fe Pellet Appliance meets the U.S. Environmental Protection Agency’s emission limits for pellet appliances sold after May 15, 2015.

  • Page 4: Glass Specifications

    SANTA FE FREESTANDING C. Glass Specifications WARNING This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please Fire Risk contact your dealer for replacement glass. Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided D.

  • Page 5: Getting Started

    SANTA FE FREESTANDING Install Guide Getting Started A. Design, Installation & Location Considerations Since pellet exhaust can contain ash, soot or sparks, you must consider the location of: 1. Appliance Location • Windows • Air Intakes NOTICE: Check building codes prior to installation. •...

  • Page 6: Thermostat Wall Control Location

    SANTA FE FREESTANDING B. Thermostat Wall Control Location WARNING The thermostat wall control’s location will have some affect on the appliance’s operation. Risk of Fire! • Maximum wire length from appliance is 100 feet • Damaged parts could impair safe operation. (30.48m) continuous non-spliced wire.

  • Page 7: Install Checklist

    SANTA FE FREESTANDING E. Install Checklist ATTENTION INSTALLER: Follow this Standard Work Checklist This standard work checklist is to be used by the installer in conjuction with, not istead of, the instructions contained in this installation manual. _________________________________________________________________________________ Customer: ______________________________________________________________________________ Date Installe: ______________________________________________________________________________ Lot / Address:...

  • Page 8: Dimensions And Clearances

    SANTA FE FREESTANDING Dimensions and Clearances A. Appliance Dimensions 2-1/2 (64mm) 12-3/4 3-3/4 (324mm) 12-3/4 (95mm) (324mm) 6-7/8 (175mm) 21-1/4 21-1/4 (540mm) (540mm) Figure 8.1 - Top View Figure 8.3 - Top View with Top Vent Adapter (TPVNT-2) and Offset Adapter (812-3570). 25-1/2 (648mm) 2-1/2...
  • Page 9 SANTA FE FREESTANDING A. Appliance Dimensions (continued) (533mm) 28-3/4 (730mm) 26-7/8 16-3/4 (653mm) (427mm) 18-1/4 (464mm) Figure 9.1 -Side View Figure 9.3 - Side View with Top Vent Adapter (TPVNT-2) and Offset Adapter (812-3570). 28-1/2 (722mm) 24-1/2 (621mm) 26-3/4 22-3/4 (681mm) (579mm) Figure 9.2 - Side View with Top Vent Adapter (TPVNT-2) and...
  • Page 10 SANTA FE FREESTANDING Installations with: B. Clearances to Combustibles (UL and ULC) TPVNT-2 Top Vent Adapter w/Heat Shield & Clean-out TPVNT-6 Top Vent Adapter with Clean-out 812-3570 (3” to 6”) Offset Adapter 811-0720 (3” to 4”) Offset Adapter Horizontal Through the Wall Inches Millimeters Back Wall to Appliance...

  • Page 11: Hearth Pad Requirements (Ul And Ulc)

    SANTA FE FREESTANDING C. Hearth Pad Requirements (UL and ULC) USA INSTALLATIONS: A non-combustible floor protection is recommended extending beneath the flue pipe when EMBER PROTECTION: It is necessary to install a Type I installed with horizontal venting or under the Top Vent floor protector.

  • Page 12: Alcove

    SANTA FE FREESTANDING D. Alcove Figure 12.2 Figure 12.1 Minimum* Maximum Inches Millimeters Inches Millimeters Height 1092 Width Depth D To Side Wall *All minimums listed are to a combustible surface. NOTE: • Illustrations reflect typical installations and are FOR DESIGN PURPOSES ONLY.

  • Page 13: Vent Information

    SANTA FE FREESTANDING Vent Information A. Venting Termination Minimum Requirements Electrical Service Inside Corner FIXED FIXED OPEN CLOSED CLOSED OPEN J or K Figure 13.1 Termination Cap Restricted Area Air Supply Inlet Gas Meter All minimum clearances are listed with an Outside Air Kit (OAK) installed, unless otherwise noted in table below. Above Finish Grade (the grade surface Above grass, top of plants, wood or any other com- 12 in.

  • Page 14: Avoiding Smoke And Odors

    SANTA FE FREESTANDING B. Avoiding Smoke and Odors • Power outages during operation will cause the appliance to immediately turn off and may create Negative Pressure, Shut-Down and Electrical Power conditions where smoke will back draft into the house. Failure In order to reduce the likelihood of smoke back drafting To reduce the probability of back-drafting or burn-back into the house during a power outage, Hearth and...

  • Page 15: Draft

    3 to 6 inch (76-152mm) Top Vent Offset Adapter, • Location of the vent termination must not obstruct use Listed double wall flue connector. A Quadra-Fire or interfere with access to the electrical service. Outside Air Kit must be used with manufactured home installations.

  • Page 16: Equivalent Feet Of Pipe

    SANTA FE FREESTANDING G. Equivalent Feet of Pipe WARNING The table below can help you calculate the equivalent feet Vent surfaces get HOT, can cause burns of pipe which is a method used to determine pellet vent size. if touched. Non-combustible shielding or Figure 16.1.

  • Page 17: Venting Systems

    Must use 3 or 4 inch (76-102mm) “L” or “PL” Listed pellet venting or Listed double wall pipe and a NOTICE: Quadra-Fire Outside Air Kit in mobile homes. Please note that while the minimum clearance for CAUTION the termination cap is 6 inches (152mm) there is the We strongly recommend that you DO NOT DOWNWARD possibility of soot build-up around the termination area.

  • Page 18: Vertical Into Existing Class A Chimney

    All three installations are approved for mobile home installations. Must use 3 or 4 inch (76 to 102mm) “L” or “PL” Listed pellet venting or Listed double wall pipe and Quadra-Fire Outside Air Kit in mobile homes. Single wall pipe is approved for residential installations only. Flashing 12 in.

  • Page 19: Masonry

    SANTA FE FREESTANDING WARNING Fire Risk Inspection of Chimney: • Masonry chimney must be in good condition. • Meets minimum standard of NFPA 211 • Factory-built chimney must be a minimum 6 inch (152mm) UL103 HT. E. Masonry Fireclay flue Concrete Cap Liner with Airspace Flashing...

  • Page 20: Appliance Set-Up

    SANTA FE FREESTANDING Appliance Set-Up A. Outside Air Kit Instructions CAUTION Parts Included in Kit: 1 piece of 2 inch x 3 foot flex hose, 2 hose clamps, 1 air intake channel1 collar assembly, 1 Never draw outside combustion air from: termination cap assembly, 1 trim ring, 12 screws.

  • Page 21: Top Vent Adapter Installation

    SANTA FE FREESTANDING B. Top Vent Adapter Installation 3 to 3 inch Top Vent Adapter 3 to 6 inch Top Vent Offset Adapter Installing the Top Vent Adapter Drill Holes in back of appliance and secure with 4 1. Put a layer of high temperature silicone on the 3 inch screws, 2 on each side (76mm) exhaust outlet.

  • Page 22: Thermostat Installation And Operation

    SANTA FE FREESTANDING 2. Use a drill with either a 3/16 drill bit for drywall or a 7/32 D. Thermostat Installation and Operation drill bit for plaster drill holes. The kit comes with a programmable wall thermostat and 3. Using a hammer tap in wall anchors. 25’...

  • Page 23: Optional Log Set Placement Instructions

    SANTA FE FREESTANDING E. Optional Log Set Placement Instructions 2 Piece Log Set Installation 1. Open door to expose the firebox. 2. Install the left log first and then the right log (Figure 23.1). 3. Lean the logs against the cast iron brick in the back of the firebox.

  • Page 24: Mobile Home Installation

    SANTA FE FREESTANDING Mobile Home Installation CAUTION You must use a Quadra-Fire Outside Air Kit for installation in a mobile home. THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/ROOF MUST BE 1. An outside air inlet must be provided for the...

  • Page 25: Reference Materials

    SANTA FE FREESTANDING Reference Materials A. Service and Maintenance Log Date of Service Performed By Description of Service August 3, 2018 7050-145L...
  • Page 26 SANTA FE FREESTANDING Date of Service Performed By Description of Service 7050-145L August 3, 2018...

  • Page 27: Accessories List

    SANTA FE FREESTANDING B. Accessories List SANTAFE-MBK Service Parts Beginning Manufacturing Date: June 2009 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor.
  • Page 28 Hearth & Home Technologies 352 Mountain House Road Halifax, PA 17032 Division of HNI INDUSTRIES Please contact your Quadra-Fire dealer with any questions or concerns. For the number of your nearest Quadra-Fire dealer log onto www.quadrafire.com CAUTION DO NOT DISCARD THIS MANUAL...

Table of Contents